It's sometimes interesting to see how other Quilters put their quilts together...
...so i thought id show you how i do mine...
I
lay my
backing fabric out on my floor (Fabric side Face down).... I
line up a selvaged edge with the lines on my
floor boards and use the floor board lines as a guide....
I use
2" Masking tape and
tape the
Bottom left corner first. See in this picture how i line up the edge of the selvage with the join on my floor... Lining this up properly, comes in handy in the next few steps...
I add
another piece of tape...to hold the fabric firm in place... I then proceed to tape the other corners...
In ORDER - Bottom Left, Bottom Right, Top Left, Top Right pulling each corner really tight. When taping each corner, I line them up along this same join in my floor boards...
Once all the corners are done.... You will find it bows up a little in the middle between corners...... This is where the floor board join comes in really handy....Starting in the middle you begin taping the Bottom selvage edge... Pulling the selvage edge down, until it is also lined up on the same floorboard line as the corners...... Repeat with Top edge and then Left and Right sides....
The back of your quilt should now look like this...
Next,
lay your batting on top... i try and use the fold in the batting as a guide and lay this fold along the join in my backing fabric....
My favourite batting to use... is 100% Cotton, Or a Bamboo Batting... There are alot of different qualities and thicknesses out there... I use a thin batting and the best quality i can buy.
Throw your
quilt top onto your batting.... I line up the centre seam in my backing fabric with the middle of my quilt.
Sometimes... a pieced back works great and you may want the seam 3/4 way down or in various other positions depending on the quilt... Just
remember to pay attention to where you want the seam and esp if you have a backing fabric that is directional... I made this mistake once... the backing was pinned upside down... took ages to unpin and redo!! SO be careful.....
Next,
Climb onto the middle of your quilt. I like to
start in the centre and
smooth out all the creases. Take your time making sure it is nice and flat...
Now comes the
pinning!!....
For me its a MUST to use proper angled safety pins (Cant remember the 'proper' name)... these are angled so when you put the pin into the three layers it easily pops back up through to secure in place...
I
start in the middle of my quilt and with my Left hand smooth the fabric out really flat and pin with my Right hand... I place
pins about 3 - 4" apart.
I constantly smooth and pin, smooth and pin...from the middle I work out towards the edges...
Once its all pinned... I cut through the three layers, about an inch away from the edge of the quilt top....
all around the edge.... It is now ready for Quilting.... mmmm yes and with this quilt...I'm a little stuck!
Everyone does baste their quilts a little different. I have learnt to do it this way through a little trial and error mixed with different techniques from a few quilt classes I took from my local quilt shop
Blueberries. I have found my quilts never crease on the back... they are always perfectly smooth and flat with no bunching... this way works for me....and
i Hope this helps some of you!! xxx
